(second generation)

Before performing this "Procedure", write on a separate sheet of paper all your current positions set on the Complex in Sections: "BODY SYSTEMS" and "DISEASE PREVENTION". You will need this later.

Actions sequence

In addition to the actions described in the User Instructions, Section 2 {using the "SvetL" Complex (p. 16-18)}, the following is required:

1. Launch the SvetL Complex Correctly.

2. In the "LOAD CONTROL" section disable the "SvetL" Program (p. 52-53) in subsections "BODY SYSTEMS" and "DISEASE PREVENTION" doing the following:

a. Click on the picture of any previously selected organ.

b. From the pop-up menu choose REMOVE ALL ORGANS AND DISEASES.

c. Confirm by clicking YES. This will nullify (clear) the LOAD CONTROL.

3. Go back to the Main screen and exit the "SvetL" Program by clicking EXIT PROGRAM.

4. Turn the Complex OFF using the on/off slider on the back of the Complex. You do not need to disconnect the cable from the computer.

5. Wait at least 10 minutes.

6. Turn the Complex ON using the on/off slider on the back side (a RED mark will appear on the slider when it is ON).

7. Re-enter the "SvetL" Program (Main screen).

8. Click LOAD CONTROL. If the LOAD CONTROL Section is empty – go back to the Main Screen. If there are any programs/positions left - repeat steps 1 - 7.

9. The load intensity Adjustment Dial must be on "100".

Enter the previously recorded positions to the Complex in accordance with the "User's Instructions". Positions can be changed at your discretion or as Recommended.

10. Exit the "SvetL" Program.

11. Turn the Complex OFF using the on/off slider. You do not need to disconnect the cable from the computer.

12. Wait at least 10 minutes.

13. After 10 minutes, turn on the "SvetL" Complex ON using the on/off slider.

Verify all positions in the LOAD CONTROL section and go to the main screen.

14. Exit the "SvetL" Program and disconnect the cable from the computer.

15. Now set the load intensity Adjustment Dial to the appropriate (comfortable) for you level.

Intensity level can be increased by no more than 10 units once every 10 days of stable comfortable state of your body.

16. Then proceed in accordance with your usual usage of the Complex "SvetL".

Further Clarification of the Complex "SvetL" reload procedure

by Feodor Shkrudnev

I would very much not like someone to distort what is written by me, especially regarding the Technology. There are things, which should be basic. The second-generation SvetL Complex does not need to be reloaded, unlike the first-generation Complex. This is how it was conceived and created.

However, there is a certain "but" based on constantly and sharply, differently from expected, changing situation with the Human Life Support System. Therefore, when moving with the Complex at a distance of more than 1,000 km, it is recommended to reload the Complex.

Don't be afraid!

Any doubts (dropped it, or so) - reload. It won't hurt.

Reload speeds up the adaptation of the Generator to the Life Support System.

"DOUBT" is a Human factor. If in doubt - reload. It's OK.

REMEMBER: Always set the intensity to 100% while setting the positions. THEN adjust the Intensity Dial to the proper level.

05. 10. 2019

Feodor Shkrudnev